Applying Vinyl Siding Starter Strip

Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip.

Applying vinyl siding starter strip.

Installing inside corner. In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level. Nail the starter strip to the siding aligning the top of the strip with the chalk line. Locate the lowest possible corner that has sheathing.

Staret strip secures the first course of siding to the home. Vinyl siding starter strips. The bottom of the starter strip the part the bottom panel hooks on to should be at least. Insulation for vinyl siding 1.

Cap the corner posts. Hold a tape measure against the exterior wall and travel. Attach j channel trim strips around windows and doors and along the eaves. Nail vertical vinyl corners to the corners of the house making sure they are plumb.

This is where the new siding will begin. Determine the lowest point of the wall that will be sided. Partly drive a nail 11 2 in. Slide it into the corner and nail it every 16 in.

13 simple vinyl siding installation tips use the wider starter strip. Snap each length of siding in place so that its bottom lip hooks under the starter strip. Pull the zip tool down while simultaneously. Position starter strip with the top edge of chalk line and allow room for corner posts.

Be sure to center the nails in their slots to. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. Mice bees and all sorts of other critters love making their home inside vinyl corner posts. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.

From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. How to install a vinyl siding starter strip step 1. Pull up as.